🤗

[bold laurel]

Hello recently I printed a part for my armor and it is too big on me not so much but doesn’t fit as well as I wanted it to be is there any way to fix it idk maybe shrink it somehow?
Thanks for the help🫶🏿

[dusky kestrel]

Hey @bold laurel, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[autumn wagon]

someone else recently asked the very same thing, the answer is no

you can of course trim some parts out and then reattach only some of the pieces to make the whole thing smaller

but if you care about your armor, you wont do that because it would look very crooked

[lone arrow]

you basically will have to reprint it but if u wanna give a shot try trimming some parts off adding some foam to make it fit u better and use a heat gun to maybe bend it a little

[quiet robin]

Or add padding on the inside so it fits good

[bold laurel]

This is a forearm part sorry that I didn’t mention that

[bold laurel]

Do you have a video of how to do that?

[lone arrow]

dont have a video but the steps are just as simple as it sounds heat it up bend it as u want

add foam to the loose spots so it fits u

[bold laurel]

kk I’ll try it thank you so much