✅ - Filament isnt pouring out all the way

[rapid seal]

Hi, I just started printing about a week now and just now I started a print that had been printing fine until the filament wasnt coming out of the nozzle but the printer was moving like it should be, it leaves prints half printed and tried to continue without any filament, theres plenty of filament thats inserted into the machine but it doesnt want to go through the nozzle sometimes, what is the problem and what do I do?

[cedar tinsel]

Hey @rapid seal, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[scenic quiver]

sounds like a clog

Cleaning out a clog

Fire up the nozzle to 230.
Take off the bowden tube.
Take off the nozzle.
Take off the coupler.
Take a piece of bowden tube and feed it through to scrape the inside of the hot end.
Put the nozzle on.
Then push filament through it and make sure it comes out straight.
Then put everything back together.
Make sure the bowden is cut straight and clean too.

[subtle rock]

Any chance you have done a temp tower recently?

[rapid seal]

whats that?

[rapid seal]

thx ill try that now

[scenic quiver]

https://www.youtube.com/watch?v=5mp2vCZ2iFc

use this

[rapid seal]

oh bet thx

[subtle rock]

srry my thought whas more that if its enabled it cools down the heigher it goes. so it just wont be hot enough anymore.

but maybe the temp is also a problem anyways if it clogs.

[rapid seal]

ohhh gotchu

[cedar tinsel]

This thread is closed now :white_check_mark: