✅ - Neptune 3 Max and upgraded to a 0.6 nozzle, need help with slicer settings... | Frankly Built's 3D Printing & Cosplay Community | Page 1

hollow bolt Jul 28, 2023, 3:22 AM

#

Just got my new Neptune 3 Max and upgraded to a 0.6 nozzle but have no idea what to set the slicer settings to in Cura. I want to start my Mando armor build but dont want to waste material if my settings arnt correct. Please help 😦

primal runeBOT Jul 28, 2023, 3:22 AM

#

Hey @hollow bolt, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

onyx igloo Jul 28, 2023, 3:28 AM

#

change layer width to 0.6mm

hollow bolt Jul 28, 2023, 4:00 AM

#

onyx igloo change layer width to 0.6mm

is that the only setting i need to change outside of the nozzle size setting?

onyx igloo Jul 28, 2023, 4:03 AM

#

yes, the rest of the settings will adapt to your nozzle size/line width settings.
unless you have manually set number

#

if you are not sure, you can always create a new profile and set the nozzle size/line width to 0.6mm

hollow bolt Jul 29, 2023, 1:30 AM

#

#

Just finished this print using the settings you suggested for the Neptune 3 Max in Cura. Is there anything else I should adjust? Seeing some really jagged layers and some very slight stringing.

#

Any help is much appreciated

#

onyx igloo Jul 29, 2023, 2:53 AM

#

dont print a benchy with a raft/brim. a benchy print is supposed to be a test print, this includes bed adhesion. print with brim defeats that purpose
your print looks good aside from the jagged layer, i barely see any stringing. calibrate your printer if you have done it before, e-steps, flow%, temp tower, retraction tower.

hollow bolt Aug 2, 2023, 12:38 AM

#

Calibrated and started my first helmet print... No idea what I'm doing wrong here... Ugh sorry for my noobishness...

#