✅ - print not sticking

[hazy walrus]

Hey guys, I’d really appreciate some help.
I’ve just replaced my heat cartridge, cleared any clogs, put a new nozzle on and tightened some stuff and now I can’t get my prints to stick. Same cura settings, same Estep calibration. I even levelled my bed. There was no valleys or lack of filament and it spread evenly with no gaps. I’ll provide a picture at a later point.
I have a cr10 v2

[clever crescent]

Hey @hazy walrus, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[dapper bridge]

i had to replace the bed brfore replacing tho chage the heat

[hazy walrus]

Here are some photos, this makes it look like the bed isn’t level, I checked it 5 times before printing

[static coral]

Did you clean it?

[hazy walrus]

Yeah, I used glass cleaner because I don’t have isopropyl

[hazy walrus]

Do you think I should go over it again?

[static coral]

Can you show us a bed level print?

[hazy walrus]

Yeah no worries, I’ll have to do it tomorrow though

[hazy walrus]

Hi, my apologies I’ve been busy with work and I also apologise for my first post, I was very annoyed at the printer at that point 😭 the issue I’m having is with z offset, I clicked it by mistake and now I don’t know how to reset it. I opened the web page for marlin but there’s a lot of information and I got overwhelmed. So my question is, how do I reset the z offset?

[naive ingot]

click the z-offset, set it to 00

[hazy walrus]

I’m not sure where to find that on my printer

[naive ingot]

https://m.youtube.com/watch?v=M94l2UCvBJQ

[hazy walrus]

Should I install the bl touch software? I don’t have all those options

[naive ingot]

If you dont have bl touch dont

Just google it, you can do it

[hazy walrus]

Found a video where someone did it through cura, so it’s sorted mot now. Thankyou for your help!

[clever crescent]

This thread is closed now :white_check_mark: