best way to print the iron man biceps?

[alpine palm]

a bit worried about really tiny parts with bigger masses the higher you go might topple over while printing

[vagrant harness]

Hey @alpine palm, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[alpine palm]

would this be a good way to do it?

[gentle horizon]

@alpine palm I would invert that... one solid print. Best to make it neck up. You're putting more mass up top the way you have it.

You'll have more support printed obviously but less risk of failure

[alpine palm]

haha print go brrrr

[alpine palm]

actually i tried that, it cost about 25 grams more filament than what im doing right now

plus id be more comfortable with 3 points origin than just 2 points trying to reach around

[gentle horizon]

well if you are trying to conserve filament that is fine I guess... to me I would waste more filament for success chance. However my budget for filament is a lot more than some. I buy direct in bulk so I get a lot cheaper and free sometimes.