✅ - AnyCubic Kobra - Layers don't stay connected, but still insanely hard to remove from hot bed. | Frankly Built's 3D Printing & Cosplay Community | Page 1

west prairie Mar 17, 2023, 2:29 AM

#

(Dagger was printed long-ways, not tall, then glued together, STL can be provided)
I've had this issue with several prints, I've read around and some have said this is an issue with layer height.
However, I haven't had this issue with printing more complex; albeit smaller shapes. It only seems to take effect when printing longer lines in something like blades/sticks/etc.
Has anyone else had this issue? Was adjusting the layer height necessary? Or was it something else?

fickle abyssBOT Mar 17, 2023, 2:29 AM

#

Hey @west prairie, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

west prairie Mar 17, 2023, 2:30 AM

#

I'm printing with ABS at 230 C', with the hotbed set to 100 C'
Happy to provide anything else!!

#

Peeling from the hotbed was also a pain! Even after heating it back up to 100C

fickle abyssBOT Apr 5, 2023, 5:51 PM

#

fickle abyss > Hey <@218214791955611648>, thank you for contributing to this forum. > Please...

This thread is closed now :white_check_mark:

#✅ - AnyCubic Kobra - Layers don't stay connected, but still insanely hard to remove from hot bed.