#✅ - Ender 5 Plus PLA settings?

1 messages · Page 1 of 1 (latest)

frigid knoll
#

Does anyone know the best PLA settings (temp+bed) for Ender 5 Plus?

I use AMZ3D PLA and usually do 200/60 for my prints, but I still get a bit of warping from time to time. I'm wondering if there's better settings than what I have.

chilly whaleBOT
#

Hey @frigid knoll, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

analog patio
#

Those temperatures may be okay but there may be other settings that you could tweak. You could also potentially need to do what I did and set up PID controllers for your bed temperature (it's a setting that you can turn on if you change your firmware, and if you want to try that I should be able to walk you through it). I use SUNLU PLA and I've had good results with 190 and 55, but I'm also experiencing some bed adherence problems right now.

analog patio
#

You could also try making sure that your bed is level. If it isn't, you may just not be getting good bed adhesion. Is the peeling coming from the same part of the bed every time?

frigid knoll
#

it's usually from the more narrow ends of the rafts

chilly whaleBOT