✅ - does this look like a nozzle clog?

[meager horizon]

Hey @past trellis, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[glad barn]

no

most likely due to the bed being unlevel

heat up the nozzle to 230, then slowly remove the filament from the nozzle

[past trellis]

ok thanks for the help

[meager horizon]

This thread is closed now :white_check_mark: