✅ - Ender3v2 calibration cube Kinda fuzzy?

[tawny rampart]

so far this is my best looking Cube and I'm pretty happy with it. but I'm curious if I could change any settings on it to make the x y or z sharper? or make the print a little bit smoother (printed with Esun pla +)

[vagrant sedge]

Hey @tawny rampart, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[forest mica]

looks like you have a clog

Fire up the nozzle to 230. Take off the Bowden. Take off the nozzle. Take off the coupler. Take some Bowden tube then feed it through to scrape the inside of the hot end. Put the nozzle on. Then push filament through it and make sure it comes out straight. Then put it back together. Make sure the bowden is cut straight and clean too

[tawny rampart]

is this part supposed to be hard to come off? I attempted to clean it yesterday but I couldn't get move that part at all

[forest mica]

make sure the nozzle is heated... remove that blue clip...

the white plunger should push and you can pull the bowden tube out

[tawny rampart]

k I'll give it another shot thanks a bunch

[vagrant sedge]

This thread is closed now :white_check_mark: