Doing some long overdue checks on my 3D printer. Surprisingly the steps were all good but the corners appear to be bulging, and just don’t look great overall. Not really sure where I should be going to fix it.
#fixing cornering
stone narwhal
gray heathBOT
Hey @stone narwhal, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
bronze prism
Doing some long overdue checks on my 3D printer. Surprisingly the steps were all...
Maybe reduce print speed?
stone narwhal
is that a common one?
my outer wall speed is 50, which seems fine and reasonable for an ender 3
bronze prism
Yeah that seems like a reasonable speed. I am not sure.
stone narwhal
ill tune it down a little. Could retraction have anything to do with it?
bronze prism
Honestly man I'm not sure I am qualified enough to answer. Could try asking in "Chat-Modeling" room, seems to be some knowledgeable ppl in there
stone narwhal
that looks like your zseam
that one in particular could be Z seam (the seams been looking rough too) But all of the corners are bulging. What would be your suggestion for cleaning it up?