#✅ - cr 10s pro v2 leveling and BL touch

3 messages · Page 1 of 1 (latest)

tranquil gulch
#

Ok so I’ve leveled this thing maybe 20 times and it’s done it’s whole 25 points on the bed with the bl touch. They are all around 0.02 and -0.02. Ok so now I would think it’s ready to print right? So I fire it up to 200 and the bed to 60 as usual and then hit print. It auto homes and then does the 25 points on the bed, and then when it starts printing the nozzle is like an eighth to a quarter of an inch above the bed and starts printing in the air. During one of these prints that was printing in the air I tried to turn the knobs so it would be up with the nozzle height and I got it there but I stopped the print because it was failing. So it should have been up to the nozzle this time at least right? But when I go to level it again using the “measuring” it does its 25 pints and then it’s back to being 1/8-1/4” above the bed. Idk if it’s the machine messing up somewhere along it’s auto leveling process or if I’m missing a step? Just unboxed this thing like 3 hours ago and have been trying to figure this out. (The Z axis compensation is -0.70 if that helps idk) Thanks

slow nexusBOT
#

Hey @tranquil gulch, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

slow nexusBOT