✅ - Need help with leveling

[dreamy oak]

I’ve had this ender 5 for over a year runs so smooth printed a 3 day print now everything is out of whack trying to re-level it and I tightened all the knobs up and I get these numbers

My question is how are all knobs tight and that 1 number is negative?

[rain vessel]

Hey @dreamy oak, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

[lucid coral]

Adjust your z height.

[bright valley]

I have two Ender 5+ printers; I never even look at the bed leveling mesh numbers. I use a bed level test print to confirm that I am where I want to be. Chasing those numbers only resulted in sheer frustration and premature greying of my hair!🤣. Results are what matters here. The only time they might be helpful is if you have a massive difference in some of the numbers indicating a warped bed, but again, print results are what matter.

[dreamy oak]

Yeah I’m just curious why that front left side is negative while rest are plus 2 positive

[dreamy oak]

I adjusted z height re-leveled the bed printed the bed level test perfect then go to print a different print and the filament coming out sticks to the nozzle and not the bed and now the nozzle to far from the bed what happened????

It’s seriously starting to frustrate me

[lucid coral]

Are you using a skirt? Please post a picture of your bed level test.

[dreamy oak]

I am using a skirt and ok let me run another and I’ll take a pic

[dreamy oak]

This is the bed level test I went and got some alcohol before this and cleaned the bed real good and it seemed to stick a lot better I’m printing a print now I’ll come back and update on results

It’s sticking a lot better are my lines fine or too far apart

[rain vessel]

This thread is closed now :white_check_mark: