✅ - cant seem to get a first layer down | Frankly Built's 3D Printing & Cosplay Community | Page 1

glad zenithBOT Nov 22, 2022, 11:45 AM

#

Hey @woven lake, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.

hollow pilot Nov 22, 2022, 1:25 PM

#

You might want to calibrate esteps and flow rate

#

From what i can see your bed is pretty level, but it extrudes more than it should, resulting in ridges and blobs

woven lake Nov 23, 2022, 1:11 AM

#

hollow pilot From what i can see your bed is pretty level, but it extrudes more than it shoul...

so i did the esteps and im getting 3mm of under extrusion not sure what setting to change though

hollow pilot Nov 23, 2022, 5:06 AM

#

What printer do you have

#

Its changed in the printer settings not cura

woven lake Nov 23, 2022, 10:03 AM

#

hollow pilot Its changed in the printer settings not cura

ok i have a cr10s pro v2

hollow pilot Nov 23, 2022, 10:06 AM

#

https://www.google.com/amp/s/letsprint3d.net/how-to-calibrate-the-extruder-steps-ender-3-5-cr-10/amp/

Let's Print 3D

Brett

How To Calibrate the Extruder Steps (Ender-3 / Ender-5 / CR-10) - L...

The correct Extruder Steps (e-steps) are a must for good 3D Prints, but the Ender-3, Ender-5 and CR-10 are almost set wrong. We look at the steps to fix it.

woven lake Nov 23, 2022, 10:12 AM

#

so i cant do it from the printer so would have to use a cable into the pc but the pc does not pick the printer up so think im stuck at this point

glad zenithBOT Nov 23, 2022, 5:16 PM

#

glad zenith > Hey <@223926536070365185>, thank you for contributing to this forum. > Please...

This thread is closed now :white_check_mark:

#✅ - cant seem to get a first layer down