Cause?
#sooo what most likely caused this?
short turret
tough timberBOT
Hey @short turret, thank you for contributing to this forum.
Please provide as much information (images, video, description) as you can. This will increase the chance that someone can help you with your issue.
Use the Close button when your issue is resolved.
short turret
too fast?
sleek dome
Not level?
grave matrix
The part in the back looks almost like under extrusion. But the weird bit in the front, have you looked into tightening your belt?
unkempt crow
Check for print head wobble too
short turret
Not level?
you take that back
short turret
Check for print head wobble too
ehh its been a while since i tighened it up
sleek dome
you take that back
Lol
short turret
The part in the back looks almost like under extrusion. But the weird bit in the...
guitar string tight right?
grave matrix
guitar string tight right?
Not quite. But just tight in general.
grave matrix
Yeah i need to know numbers before i blame settings
short turret
level my bed.... smh
sleek dome
is speed an issue?
Ur gunna wanna print a bit slower if ur build plate is wobbly
sleek dome
Inner wall a bit high
grave matrix
That might be a bit fast. But this could be all a mix of several things. Tune up the hardware, check belts and such. Then slow everything to normal just to see if the issue persists
sleek dome
Could also be ur build plate being too hot and lifting the beginning layers up
short turret
Actuaoly
Ya are right
I did see something peel up and curl
It was the inner part of the support
sleek dome
Yeah it’s probably that then
I like to keep mine around 50-60 degrees
Also a lot of stringing and little bumps could indicate ur plastic isn’t dry enough
keen gate
Doing curves like that is difficult at high speed because you’re basically dragging the filament off the part if you’re not melting it enough
sturdy hill
Under extrusion, clog, moisture filament, not level and last is nozzle to close to bed
short turret
wait whats under extrusion?
eternal willow