supports not touching object? | Frankly Built's 3D Printing & Cosplay Community | Page 1

hard sail Oct 22, 2022, 1:57 PM

#

🤷‍♂️

#

Also y’all think this is the best way to print?

wary reef Oct 22, 2022, 10:25 PM

#

Can we get a better pic of your support setting

lapis frost Oct 23, 2022, 12:53 PM

#

No this is not nearly the best way to print actually it’s the worst way possible

hard sail Oct 23, 2022, 2:59 PM

#

wary reef Can we get a better pic of your support setting

I will later today, I just printed it and it literally just printed with out the object touching the supports. Surprisingly it did need them but still weird it put them On There but didn’t touch the object

sick anchor Oct 23, 2022, 3:15 PM

#

Usually there’s one layer height of distance between the support and the part; it’s normal. However, you shouldnt need support on a 45 degree slope like that anyway

hard sail Oct 23, 2022, 4:01 PM

#

sick anchor Usually there’s one layer height of distance between the support and the part; i...

Yea it printed just fine but the gap was larger the one layer hight 🤷‍♂️

sick anchor Oct 23, 2022, 4:02 PM

#

i think thats how it generates supports once you cross 45 degrees

#

cuz theres no interface it can make

#supports not touching object?