Whenever i try to print on my printer the bl touch it will bend. Anyone know a answer to why might it be bending? It might have something to do with my gantry or that i printing multiple part at a time. I’m to tired of buying a lot of bl touch tips. If you know a answer please don’t be afraid to answer me. Thank you for reading this and have a good day.
#my BL Touch on my CR-10S-Pro-V2 keeps bending when i try to print.
toxic merlin
trim copper
got a picture or video?
toxic merlin
I sadly don't have a picture but I i can say it does blick red and after everyprint it will centanlt be bent
certantly
toxic merlin
got a picture or video?
why do you ask?
trim copper
It will help us to diagnose what the problem is
its really hard to determine what cause the bending from words alone
autumn tulip
Is the tip not retracting? It shouldn't be able to bend during a print if it retracts because the tip of the probe when retracted should be higher than your nozzle. So the tip of the bltouch shouldn't be touching the bed or anything when printing
autumn tulip
Is your printer starting up or something? Usually the constant flashing on the bltouch. Usually means it's not working properly or it was interrupted while deploying from what u have experienced.
On a side note from that though, the carriage should not be that loose. You gotta take a wrench and tight the eccentric nut on the bottom wheel of the carriage. You tighten it just till the carriage stops having any shake or wobble to it
This is the eccentric nut
toxic merlin
thank you so much for the help i will a 100% try that later tonight or tomorrow morning. you have been the biggest help!
toxic merlin
This is the eccentric nut
which nut?
thank you
sorry did not see the arrow
had to click on image
autumn tulip
sorry did not see the arrow
no problem, realized it after I should of drew it thicker to make it more noticeable lol
toxic merlin
your fine, i should have clicked on the image.