Raft lines not looking right. | Frankly Built's 3D Printing & Cosplay Community | Page 1

full crypt Oct 19, 2022, 4:15 PM

#

Any advice on why my raft lines are coming out so thin would be helpful. i fear my walls will do the same. This isnt that an important print. only trying to get the Ultimaker S5 dialed in properly. I have checked for clogs and have done cold and hot pulls of the extruder. Does anybody have any ideas. Thanks in advance.

mild ermine Oct 19, 2022, 4:17 PM

#

Looks like a clog. Check your e-steps. Maybe its not putting out enough plastic

#

Assuming it isn't clogged I mean.

full crypt Oct 19, 2022, 4:20 PM

#

mild ermine Looks like a clog. Check your e-steps. Maybe its not putting out enough plasti...

e-steps?

nimble helm Oct 19, 2022, 4:22 PM

#

Could also be your nozzles too close. Or temps being wrong

mild ermine Oct 19, 2022, 4:23 PM

#

How much the extruder motor turns to push plastic into the hot end. Tons of videos on YouTube about it.

full crypt Oct 19, 2022, 4:30 PM

#

mild ermine How much the extruder motor turns to push plastic into the hot end. Tons of vid...

currently doing that now. thank you so much

nimble helm Oct 19, 2022, 4:32 PM

#

Are you doing it using pronterface or just the UI on your machine?

#Raft lines not looking right.