support material stuck | Frankly Built's 3D Printing & Cosplay Community | Page 1

runic panther Oct 6, 2022, 5:53 PM

#

Does anyone else have problems when printing done pieces on their back where the supports just refuse to come off? I’m not even looking for a clean break since I have to finish it anyways but getting it off at all is just not working

oak garden Oct 6, 2022, 5:55 PM

#

yup... sometimes you can get your spatula under it and get it in chunks

runic panther Oct 6, 2022, 5:56 PM

#

oak garden yup... sometimes you can get your spatula under it and get it in chunks

I’ve been trying the spatula I can’t seem to get under it at all

oak garden Oct 6, 2022, 6:01 PM

#

can take your sander to it too then spatula it ... sander will soften it

runic panther Oct 6, 2022, 6:02 PM

#

I just put some rubbing alcohol on the edges of it to weaken the plastic and I’m starting to be able to wiggle my spatula under now. Thank you

oak garden Oct 6, 2022, 6:02 PM

#

np..

#support material stuck