I was wondering if there is a way to not print certain supports. Like if they are tall and skinny. Am I able to pick and choose which supports I want printed?
#can supports be removed from Cura before printing
fluid nexus
coral nexus
Add a support blocker
eternal talon
I was wondering if there is a way to not print certain supports. Like if they ar...
Go to the market place and enable custom supports
obsidian thorn
spice turret
I have support blocker but I can’t understand how to use it?
fluid nexus
Can I still use some of the supports the Cura suggests? And delete the ones I don't want?
obsidian thorn
you make a cube... where you dont want supports
eternal talon
Just scale it up and position it to where you want there to be no supports
eternal talon
Can I still use some of the supports the Cura suggests? And delete the ones I do...
Yea If you block some of them the rest will still generate
A support blocker only affects the part it is covering
fluid nexus
Awesome I will try that later when I get home from work. But I also wish there was a way to stop a support from printing that has failed
eternal talon
Yep it would make life so much easier
obsidian thorn
If supports are failing you have another issue. Underextrusion or a loose belt or something
fluid nexus
Most of the time the supports start out great, but somehow get knocked off. Sometimes I can save it with super glue and 120lb card stock, or painters tape
eternal talon
Do you use rafts
obsidian thorn
Sounds like another issue. Supports shouldn’t fail
fluid nexus
I think its my nozzle that might be knocking it off. Or the bowden tube and the power cord that is hanging to low and knocking the print off
obsidian thorn
Try turning on z hop
fluid nexus
I have that on now. And I'm currently printing Walsh Mark XXXIX chin. So we'll see if that helps
But what should I do about the sagging bowden tube, and power cable.
patent sonnet
you can also set minimum support sizes