I put a fly e3 board into my ender 5pro with klicky i had it all working but noticed my homing took too long so dove into the deploy probe and commands and found out its measuring the zheight on deploy probe not home Z so in home all or home z i told it to probe the center of the bed but it probed where the depoly probe macro ended dosnt move after then it retracts it also dosnt go back to home and stay it homes then goes somwhere else
#Weird homing Error after turning my ender 5pro with klicky to rrf in general new dwc config 3.5.2
lavish tangle
Weird homing Error after turning my ender 5pro with klicky to rrf in general new dwc config 3.5.2
uncut cave
best post your files
lavish tangle
will do
there is 2 weird home is in the video the other works but instead of home z or home all telling it where to probes it uses deploy probes last move as the probe location
uncut cave
it will probe whereever the deploy macro finishes as that comes after the command to move to the centre
lavish tangle
is there no way with rrf for deployprobe macro litteraly is just go and grab the probe where as home z and homeall will dictate placement of that probe point since it picked it up
uncut cave
you could run M401 to deploy it and M402 to retract it
lavish tangle
cause in all honesty i thought you had to call m401 to even deploy probe this is new to me
uncut cave
it automatically gets deployed for G30 if there are deploy and retract files present
lavish tangle
see yeah its calling g30 in home z and home all but even if i do G30 p0 X110 Y110 it dosnt probe there
uncut cave
you can't pass co-ordinates like that for a normal probe
so M401 G1 X117 Y117 G30 M402
digital basalt
it automatically gets deployed for G30 if there are deploy and retract files pre...
Ooooooh. Didn't know that.
Makes a lot more sense
lavish tangle
you can't pass co-ordinates like that for a normal probe
In home z and home all right do I need to change the deploy probe and retract sys macros
uncut cave
No, I think what you have looks ok
lavish tangle
Dope ok will test in a min just got off work
uncut cave
You may want to consider not using M564 to turn off movement protection and use G1 H2 instead
lavish tangle
This was all stuff I copied and pasted and made work any ideas to fix it and make it faster I'm all for it I'm getting back into 3d printers and yeah almost caught 1 on fire due to its oem sidewinder wiring and then swapped boards
So ender 3v2 now has a fly e3pro v3 and ender 5 has the fly e3
uncut cave
I think @normal parcel has some examples of deploy and retract code in his repo
normal parcel
yeah they are in the Micron/sys section part of my Voron-2.4 configs. link in my discord profile should just need to understand them and change the dock location. Read bed.g and the homez.g files too they sorta all work together
hmm I really should put comments in the files. just ask if you have questions 🙂 I'll try and update them this weekend with clear explanations. Basically the big one is not call M402 and the end of bed.g cuz that is taken care of in the G28 Z at the end. trying to reduce the deploy and stow cycles to speed up klicky use.
lavish tangle
hmm I really should put comments in the files. just ask if you have questions 🙂...
... i might be a little high to read this but i will try
lavish tangle
hmm I really should put comments in the files. just ask if you have questions 🙂...
this bed.g is more than mine where its a few things.. but its cool i like the 4 probe points for screw calibration or smth also i got it to work thank you apparently i need to smoke more