rustic edge
Hello, recently printed this project and setting it up. I have it running in arduino IDE and can see the outputs in the serial log without issue. I close aruino and launch deej-debug.exe and when I move my sliders nothing changes and there's no output on the debug screen (when moving sliders, booting up it shows connected.) I have uploaded the output of the debug exe and heres my yaml file
# you can use 'master' to indicate the master channel, or a list of process names to create a group
# you can use 'mic' to control your mic input level (uses the default recording device)
# you can use 'deej.unmapped' to control all apps that aren't bound to any slider (this ignores master, system, mic and device-targeting sessions) (experimental)
# windows only - you can use 'deej.current' to control the currently active app (whether full-screen or not) (experimental)
# windows only - you can use a device's full name, i.e. "Speakers (Realtek High Definition Audio)", to bind it. this works for both output and input devices
# windows only - you can use 'system' to control the "system sounds" volume
# important: slider indexes start at 0, regardless of which analog pins you're using!
slider_mapping:
0: master
1: chrome.exe
2: spotify.exe
3:
- pathofexile_x64.exe
- rocketleague.exe
- cs2.exe
4: discord.exe
# set this to true if you want the controls inverted (i.e. top is 0%, bottom is 100%)
invert_sliders: true
# settings for connecting to the arduino board
com_port: COM8
baud_rate: 9600
# adjust the amount of signal noise reduction depending on your hardware quality
# supported values are "low" (excellent hardware), "default" (regular hardware) or "high" (bad, noisy hardware)
noise_reduction: default```
split bay
