Not sure if this is a hardware problem or what. But on the serial monitor when i turn any pot to wither extreme the pot next to it is changed, to the point that i cant even fully mute something if the one next to it is about 70%. I wired the pots in parallel with separate data to the board.
#My pots are controlling multiple values.
brittle plaza
brittle plaza
anybody help out with this its driving me crazy
tiny hill
We need more info.. What mcu.. Pictures of your wiring.. What voltage are you putting on the pots
shrewd stirrup
Wonder if thats a loose nut. Especially with a pot - if that starts turning and pulling cables, the others may be in trouble too.
tiny hill
Wonder if thats a loose nut. Especially with a pot - if that starts turning and ...
i feel that it is a 5v/3.3v thing, i think he has 5v connected to the pots but the MCU is 3.3v, so the 70% thing is overvoltaging the MCU on the pin, and affecting the other analog Inputs
i just needed information to confirm this
shrewd stirrup
i just needed information to confirm this
Its ok, plainly a simple to check option to validate.
marsh pier
Post config.ymal
royal iris
Im using a Led strip along side and when i use the led code i have similar issues. I don't have any trouble with the base code. Any ideas?
Board: Arduino Nano (aliexpress special)
tiny hill
Do you have your pots wired correctly? Can you post some wiring photos?
royal iris
Yes they work correctly with the standard deej code it works normally. it's just when I implement the led code into the system.
tiny hill
i am trying to see what the problem is