b103 slider + stm32 wiring

[slow jetty]

Hey there, just got all the parts in for my deej build and started putting it together. Got a question about wiring up the sliders with the stm32 – could you help out with that? Also, which side should be for maximum and which for minimum? Thanks!

[stray scarab]

hey, the side is your preference

you can just switch the wires to invert the maximum and minimum sides

[stray scarab]

also, are there 4 pins on each slider? 2 on each side?

[slow jetty]

There 4 pins on top, and 2 on bottom

[stray scarab]

do you know the model number of those sliders?

where did you buy them from?

[twin blaze]

https://media.discordapp.net/attachments/1223644462861910096/1223651038826074212/unknown-28.png?ex=661aa0d5&is=66082bd5&hm=e7a2459da7dfe09ca1cf9daa380830caea9e0145670d5cadb149616da72dee2f&=&format=webp&quality=lossless

Blank has a good picture

[slow jetty]

Here is "b103" on the back side, 10k ohm, linear, aliexpress

[stray scarab]

I am saving this

thanks

[stray scarab]

so you only need to wire 1 group?

[twin blaze]

I'm pretty sure yeah, I think they're stereo faders so they can modify two audio channels at once, we're just not using them for audio in that same sense

[uneven tusk]

Also, you can invert the sliders in the config yml file.

[uneven tusk]

Just make sure you wire all the pots in the same order. So you can invert them all together. Not sure if you can invert them individually using config.yaml