everything is plugged in correctly, the firmware is up to date and im not sure if the screen is up to date, i can see models when i press print, when i select a model and actually try to print it the screen goes black and nothing prints, the device doesnt even move, faulty product? or just a bug?
#anyone here familiar with the anycubic vyper? im having alot of trouble with mine i could use some h
grave plinth
regal mason
Not very familiar with Anycubic, but...probably faulty. I wish you luck if you try to contact their customer service team though; unless they've improved since last I heard, they're...not great. :/
grave plinth
ok
winter fog
ok
I've read about a different printer with a similar issue. Are you in a country with 115V mains or 230V?
grave plinth
I've read about a different printer with a similar issue. Are you in a country w...
the printer has a switch on the back and i can switch it between 115 and 230
i just learned this actually, i just flipped it im going to see if that works
winter fog
yes but what kind of voltage do you have in your house?
grave plinth
not sure
grave plinth
usa
winter fog
OK that should be 115V
grave plinth
not sure where i would check my house voltage
winter fog
not sure where i would check my house voltage
It's the same in the whole country basically.
grave plinth
its been on 230 this whole time so perhaps its been short circuiting or something
probably tries to apply 230 but gets cut off cause my power is 115
i can see that
winter fog
Not a short circuit just expecting to be feed 230V and only getting 115V so it's under powered.