Defect on print | 3DMeltdown 3D Printing | Page 1

keen pulsar Jul 12, 2022, 12:18 PM

#

What causes this defect on the rounded corner of my print? It sometimes happens.. sometimes doesn't. PLA+ 215c at 120mm/s.

#

#

I've tried changing orientation

#

in case it was a cooling failure

#

but didn't seem to change

#

and it always seems to be in the same place

maiden zealot Jul 12, 2022, 12:20 PM

#

Is it an overhang?

keen pulsar Jul 12, 2022, 12:22 PM

#

not really

#

its like the second picture

#

slightly curved

oak sage Jul 12, 2022, 5:26 PM

#

looks like pressure/linear advance needs tuned

narrow dome Jul 12, 2022, 11:48 PM

#

did you update to the newest cura version

keen pulsar Jul 13, 2022, 3:07 AM

#

i dont use cura

#

it must be a cooling thing or something

#

i rotated it 45 degrees again

#

the opposite direction

#Defect on print