Guys, I enabled support, tried using both tree and normal, added threshold angle, slow down overhang speed of each percentage by 10 mm/s, top z distance 0.2
And it still came out like that
Can anyone please help what should I change or do?
#Can anyone help me with stringy overhangs?
golden skiff
proud dome
This is expected for a support interface.
You can make them "tighter" by reducing the gap between the support interface and the part, but that comes at the cost of you might not be able to remove the supports easily
golden skiff
You can make them "tighter" by reducing the gap between the support interface an...
I see, beside that is there no way that it came out rather smoothly? I seen ppl that prints helmet or action figure with weird shapes came out very smooth but I haven't tried any material beside PLA tho if that matters
proud dome
Their support interfaces likely look similar.