nocturne willow
When I say I haven't gotten a functioning print since like, the middle of June when I changed my filament cause I ran out. I mean it cause this is trying to kill me a week before I become a legal adult like why.
What I've tried:
-re leveling the bed
-drying the filament
-gluing the base for more adhesion
-cleaning the fans
-checking the hot end for problems
I need an adult please
The other print i remembered to take a picture of that failed
steady stag
steady stag
When I say I haven't gotten a functioning print since like, the middle of June w...
Tilted motor mounts by design = z binding
steady stag
The other print i remembered to take a picture of that failed
Too close to the edge of the print bed. The slicer usally leaves a 5mm safe area to the edge to avoid hitting the end of the axis to prevent skipping and pilling up filament.
steady stag
The other print i remembered to take a picture of that failed
Too high layerheight. Max layerheight is .3 mm at a .4 nozzle ... wouldnt go higher then .2mm
And i think the x axis is tilted and and check the hotend if its leaking when at 220c
nocturne willow
And i think the x axis is tilted and and check the hotend if its leaking when at...
I print at 200c and haven't had problems before this
nocturne willow
Also the hot end seems fine, only thing is it has a small bit of filament on it that I couldn't get with the big clumps when I had a filament leak, just the stuff you can get with a rag (of which i don't have to basically ruin)
Also genuinely thank you for giving me actual issues to fix rather than the vibes I was going off of
steady stag
I print at 200c and haven't had problems before this
The thing is a hotend needs to be assembeld at max temp to work reliably. Creality is unable to do that. Otherwise thermal expansion is guaranteed to destroy at least 1 hotend
And you are welcome 🙂
nocturne willow
Ok just to make myself a little checklist and double check i understood the problems
Also wait is leaking when it comes out of the nozzle on its own or smthn else
Nvm im tripping
But also the slicer says its layer height is at .2
steady stag
For all or first layer only
The ender 3 often has the issue that the endstop for z is mounted too high. Which leads to less tension on the bed springs giving you a unreliable bed.
So you can try moving it down a bit giving you more spring tension
nocturne willow
For all or first layer only
for the whole print
i've spent like, at least half an hour bed leveling and watching the video in the print link and fuck it like, annihilated my resolve it's almost impressive
i got my printer not even a month and a half ago pre-owned so i'm super lost and it's fucking me up
nocturne willow
so imma deal with this tmmrw
steady stag
Good luck 🙂 creality printers are only cheap the rest is hard mode
nocturne willow
I see that lol
wide jackal
I didnt read the entire chat here, but the issue seems like the z-distance is too much, the nozzle is too far from the bed maybe? you didnt state that you tweaked that
nocturne willow
Ngl I never touch the extruder setting on it cause it lowkey scares me
steady stag
So did any of my tips help or are still poking the printer with a stick incase it bites?
nocturne willow
I've done a couple upgrades and most of the stuff you said to fix it
Pretty much just the zbanding stuff is left and getting the cr touch working
pure leaf
You said it was a new roll of filly, what did you buy? And what settings are you trying..
nocturne willow
You said it was a new roll of filly, what did you buy? And what settings are you...
Ngl I do not remember it's at a whole different house rn
