Stringing or oozing problem | 3DMeltdown 3D Printing | Page 1

gleaming mantle Feb 3, 2025, 5:04 AM

#

Dried my pla for 8 hrs at 55°. I have not yet calibrated my extrusion multiplier but I calibrated flow and my extruder. I print pla at 220° in this retraction test from 0 to 4mm retraction length at 0.1 increments.

#

My printer is a klippered ender 3 with a sherpa micro and minime duct

south sierra Feb 3, 2025, 1:34 PM

#

Does it do that with every filament or only that one

gleaming mantle Feb 6, 2025, 4:56 PM

#

south sierra Does it do that with every filament or only that one

only this one

south sierra Feb 6, 2025, 4:56 PM

#

Have you tried printing it a bit cooler

#

Maybe like 210

#

Or do a temp tower and see if it stops stringing at any point

gleaming mantle Feb 8, 2025, 10:30 AM

#

south sierra Have you tried printing it a bit cooler

Thanks man, it worked

#

190 seems to be the best

#

this esun pla+ recommends 205-220 but 190 seems to be the sweet spot :))

#Stringing or oozing problem