Bl touch mesh inaccurate. | 3DMeltdown 3D Printing | Page 1

lean cloud Dec 16, 2024, 7:26 PM

#

#

The probe seems to think the left side of the bed is super low and the right is super high, I’ve leveled the bed by hand and gotten it pretty good. I’ve tried insulating the wiring and even wrapped the probe in foil thinking it might be EMI because that’s where the board is mounted but that didn’t do anything

lean cloud Dec 16, 2024, 9:33 PM

#

Deactivating the mesh in cura fixed it so that rules out a problem with the bed

normal musk Dec 22, 2024, 2:26 PM

#

lean cloud Deactivating the mesh in cura fixed it so that rules out a problem with the bed

Not nescessarily, but it is very clear that bed is not, in fact, snapped in half :p
Is this a genuine BLTouch or a clone knockoff? The clones are known to be of.... inconsistent quality

#

Or, they were last I was tinkering, which admittedly has been a while

lean cloud Dec 22, 2024, 4:31 PM

#

The one on it there is a clone but I have an actual one on my other printer that I pulled off of that and put onto this one and it did the same thing, I put on the single extruder and it seems to work now so it might be something wrong with either how it’s mounted or the weight of the dual extruder on the rods

versed meteor Dec 22, 2024, 4:54 PM

#

maybe the stepper motors create some noise in the wiring that delivers false results

#

but I don't know if that leads to this tipe of result
maybe some gain values are set up wrong in the firmware

#Bl touch mesh inaccurate.