I just got the SV06 and printed the calibration cube on the default settings, the X axis seems to be the most problematic. Does anyone have any suggestions? Thank you!
#Sovol SV06 XYZ Calibration Cube Issue
quaint kernel
I call upon @finite echo to the stand.
To me it looks like belts might be loose but im not sure.
finite echo
Cursed calicubes at 3 am
I guess ypu selected the wrong material and the partcooling fan was off?
Or .1 mm layerheight
flat jasper
Looks overextruded and with poor cooling.
What slicer are you using? What settings? What material?
What are the "default settings"?
lean elk
I call upon <@428869805601193994> to the stand.
To me it looks like belts migh...
I think that could be it, I just checked and it was super loose, let me print that cube again
lean elk
cube still looks the same
lean elk
after some playing around it looks way better, the only issue left (new issue) the first layer looks like its shrinking
could that be because its getting cooled too fast? or is the nozzle too far off the bed? or could it be both
quaint kernel
What material are you printing with? PLA bed should be 60 degrees if you can. Ive had good results with that in the past. Nozzle 200-220? Fan speed 70-80%.
finite echo
There a option called xy compensation. Its too prevent elephant foot maybe you have a too high value there
Or thar the firstlayer is set too .3 mm ... click on the 3 stripes next too the search field and select all
lean elk
What material are you printing with? PLA bed should be 60 degrees if you can. Iv...
Yeah PLA, nozzle was 200 and bed was 60
ill double check the speed
lean elk
Or thar the firstlayer is set too .3 mm ... click on the 3 stripes next too the ...
let me check thank you guys!