inconsistent layers on side of print | 3DMeltdown 3D Printing | Page 1

next lynx Mar 19, 2024, 11:58 PM

#

Using varioShore TPU @220c, 75% flow. This is a cube flow test w/o infill or top/bottom.

The wall width is spot on, but I get these layers. I've tried the test at different flows with the same issue.

swift ether Mar 20, 2024, 8:22 PM

#

Is it warping up off the bed?

next lynx Mar 20, 2024, 9:38 PM

#

\No, after a lot more digging, it ended up just happening when it was 1-wall. Adding two walls & it's completely resolved

#inconsistent layers on side of print