red vector
The printer was printing normaly untill i got the error "mintemp something" and the printer said that the hotend was -77 degrees, i replaced the temp sensor (its know to be bad so i have a couple spares) but i still get the same error, what could cause this error? I dont think a wire just came loose during print but what do i know, has anyone else had this issue?
last vapor
what type of sensor is it?
wraith vapor
Did you set the correct value for resistance?
nocturne tartan
did you select the correct pin readout?
red vector
what type of sensor is it?
standard cr-10
red vector
Did you set the correct value for resistance?
i took the default for the cr-10 profile
red vector
did you select the correct pin readout?
it has worked before, it just cancled mid print and i cant get it to work again
i tried with a third thermistor, same batch as i boght the other one in and instead of resoldering the resistor (as ive needed to to because of the cr-10 design) and plugged it directly into the pins on the mobo i got a correct reading
So that would indicate that the wire is shorting/ broken somewhere in between the hotend and the mobo
last vapor
So that would indicate that the wire is shorting/ broken somewhere in between th...
sounds about right.. the connection where you soldered is probably breaking from the wire movement..
have you checked already?