tight lance
Hey everyone, I’m having a problem with my ender 3 v2 printer and it’s having trouble printing some lines on specific areas of the print as shown in the pictures, I’m new to 3d printing so i don’t really know what to do, I tried leveling the bed multiple times and it still has this problem for all of my prints, if anyone can help, it will be greatly appreciated
split rampart
Make sure your belts are tight and your z axis rod is screwed in place correctly
It looks like your z axis might be slipping 😳
tight lance
Okay I’ll try fixing this thanks you🫶
tight lance
It looks like your z axis might be slipping 😳
Wait sorry but what does this mean(again I’m new to printing so idk everything by name)
split rampart
So basically when you were assembling your printer there is a rod that the up and down axis sits on
If it isnt tightened correctly it could skip a couple of turns or it can be on pretty weak so itll slip
tight lance
Oh okay so I should tighten the two bolts right here
split rampart
Just the one on top
And make sure not to overtighten
The rod should not be held by the one on the bottom
tight lance
Okay I’ll tighten rn
split rampart
👍🏽
tight lance
Okay it’s tightened so ima try a print, already though i tested moving the extruded all the way up the printer and it didn’t seem to skip anything so hopefully it works, thanks for everything🫶
split rampart
Make sure ur other belts are tightened too
Youre welcome
There are blue knobs
One in the front and one on the x axis
tight lance
Yea I tightened them too
split rampart
Left to right
tight lance
That’s right
split rampart
Alright sweet give it a lil test
tight lance
Alright sweet give it a lil test
Print came out so much better tysm
split rampart
Damnnnnn thats pretty fuckin solid