spark anchor
My termistor cable snapped while cleaning the nozzle and now I hope that I can change only the thermistor and the printer will work once more, if not then I need to change the whole hotend and I don't know which hot ends are compatible with my cr10 smart.
fallen stream
You only need a new tempsensor
spark anchor
Does it matter if the thermistor is from cr10 smart pro or any other printers?
fallen stream
Dont think so
spark anchor
OK tnx
spark anchor
now i have a problem that i cant get the new thermistor, i bougt two of them but both of them were for difrent hotends
im looking for the right code/name of cr10 smart thermistor but cant find any info about that
fallen stream
You should be able to correct it via pid tune maybe. I dont know the cr smart firmware that sell because the printer did not sell so good.
spark anchor
A ok
fallen stream
Yeah sorry :/ im not sure what was bigger mess the ender 7 or cr smart...
spark anchor
OK good to know
But are there any datasheets for termistor or heating blocks that would mention what kind of termistor it is, anything at all?
And tnx for the help
fallen stream
Hmm maybe in the manual? I think the smart uses a uncommon creality hotend ... @vernal wing do you have an idea?
spark anchor
Hmm maybe in the manual? I think the smart uses a uncommon creality hotend ... <...
I looked at the original manual of printer and it's hottend but it was user manual and it didn't specify what kind of components are used in hotend
fallen stream
Hm normaly they use a ntc 100k sensor it might look different but should work
spark anchor
Ok thank you very much will inform you if it works
fallen stream
vernal wing
Hmm maybe in the manual? I think the smart uses a uncommon creality hotend ... <...
Its an oddball one used only on a few machines, its a typical thermistor type though
vernal wing
Yeah sorry :/ im not sure what was bigger mess the ender 7 or cr smart...
Ender 7 was actually pretty decent once the undersized power supply was replaced and good with the tinymachines belted dual z kit
performance of that machine really took a hit with the undersized power supply...
ironic you mention the E7 though, same hotend assembly
fallen stream
@vernal wing i cant keep up with all version and undocumented changes ^_^ but i remember the e7 as a printer where you cant check the first layer and as fake core xy
vernal wing
<@491342503111557123> i cant keep up with all version and undocumented changes ^...
It was hard to see but the XY motion was pretty robust. I do recall joel telling cutting the front off one though
spark anchor
i installed the thermistor and it is partly working, like on start up it works fine, i put the tem to 150 and leave it there for 2-3 h it works fine, then i adjust the tem to 180 its stops working, i turn of the printer and try again but now i put it immediately on tem 230 it climes up to 220 and stops working
any easy solution to that?