ender 3 V3 fail help?

[minor crown]

I am not sure what went wrong if I could have some guidance that would be great thank you

[frigid pebble]

Belt tension

[late maple]

Looks more like an adhesion issue

Bottom print didn’t adhere and it dragged it

[minor crown]

What should I do to resolve this problem

[late maple]

Level your bed properly, and wipe your bed off with isopropyl alcohol

Keep your fingers away from the bed, skin oils mess up adhesion

[minor crown]

Ok I will do that thank you for your help

[late maple]

If that doesn’t work, we can take @frigid pebble ‘s route and try tightening your belts

[minor crown]

I will try printing again and show results

[minor crown]

Ok

[late maple]

Alright

[frigid pebble]

Or the bed hits the back of the box not much space left there

[late maple]

Bed doesn’t go out much farther than the motor so unless they have the motor pressed up against the back of it then it should be fine

[frigid pebble]

How much space do you think is left there

Also bad for heat bed cable

@late maple

[late maple]

Enough for the rear to motor

[frigid pebble]

If you say so. I remember the bed going more then 5 cm over the motor and that looks like the layershift

[late maple]

We’ll just have to wait for OP