fxcking ender 3 s1 issue's cant stick help me

[warm gull]

Clean the bed with water and soap and check if there is G29 or M420 S1 in it

[sinful whale]

What is G29 or M420 S1? And will I wash it under the tap?

[warm gull]

Yes anf G29 and M420 S1 are gcodes related to thr auto bed level feature of the s1 because there is a chance its just off

[sinful whale]

how do i check

[sinful whale]

Is there a video on how to wash the table? I usually wipe it with cologne and wet wipes and dry it.

@warm gull video says clean it with 70% isopropyl alcohol, do I need to do this?

[warm gull]

Just water and soap ipa doesnt remove everything especially finger grease

https://youtu.be/uuGQt9-3ISI?si=0EUu3xkT8Cpzrqzq

[sinful whale]

dish soap hand soap?

And do I have to do this under running water?

[warm gull]

Dish and yes

[sinful whale]

here the start gcode

; Ender 3 S1 Start G-code
; M413 S0 ; Disable power loss recovery
G92 E0 ; Reset Extruder

; Prep surfaces before auto home for better accuracy
M140 S{material_bed_temperature_layer_0}
M104 S{material_print_temperature_layer_0}

G28 O ; Home all untrusted axes
G1 Z10.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X0 Y0

M190 S{material_bed_temperature_layer_0}
M109 S{material_print_temperature_layer_0}

G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

What should I edit?

[warm gull]

Its shown in the video....

Reset your z off set add G29 below G28 and then adjust your z offset during a print and save that

[sinful whale]

I couldn't understand it very well because I barely understand English, the subtitles were showing broken.

[sinful whale]

@warm gull im added g29 but 1 times or all prints ?

@warm gull im added g29 but didint printing test print

what the fuck

speedy down

[warm gull]

it didnt print?