Doesn't happen with a black filament I have from creality (I've printed way more from that black spool) This is Polyterra Muted Blue PLA, running on default settings with 200/50 temps on an Ender 3 V2.
#pretty sure this filament sucks, any ideas?
queen loom
I dried it a while ago down to a reported 17% (give or take) humidity in a dryer I purchased. Ran for some 16 hours
And stuck it in a sealed bag (that it came in) with a dessicant packet that it also came with, only came out when it was time to use it
I am printing on a pei sheet
orchid swan
could also happen if you are too close
queen loom
Adhesion sucks sometimes too
I'm pretty sure it's fine but I'll double check it
Some previous prints had popping while printing and small holes in the final print
queen loom
Resolved to a slightly higher temperature and leaving it in a dryer for 100% of the time it is printing and allowing it to feed out of it
Finally some cleaner prints
orchid swan
Wuhu
queen loom
Weirdly with that filament my dryer won't go under a reported 17% humidity meanwhile I hit 9% on a new filament from the same brand
timber bolt
Doesn't happen with a black filament I have from creality (I've printed way more...
Different filaments may need different temperatures for one, and I’ve had a lot of filaments that I’ve gotten lately need to be dried straight out of the packing. Do you hear any kind of popping from the nozzle as it prints. Or see tiny bubbles?
Sorry, it didn’t load the answers before I sent mine. Ignore me.