Bed Adhesion | 3DMeltdown 3D Printing | Page 1

stone bridge Jul 31, 2023, 8:52 AM

#

Try it with your fans off and a bigger layer height for the first layer

dire canyon Jul 31, 2023, 8:55 AM

#

I'll try that right away, thanks!

dire canyon Jul 31, 2023, 9:11 AM

#

Sadly it failed still! Could it be poor quality filament?

heady sleet Jul 31, 2023, 9:44 AM

#

make sure ur glass bed is clean

#

i would clean it with water and soap

#

i would also scrub the bed sith a spong(the soft side) to prevent scratching

#

make sure to check ur z offset

#

and manually levelling the bed

#

there are a ton of videos that explain each step

#

you could also try using a glue stick

#

just rub glue on the build surface

#

also what printer do oyu use

dire canyon Jul 31, 2023, 10:01 AM

#

I am using a CR-10 mini, I have tried the glue stick already lol + seen a ton of videos, yet nothing works! I'm starting to think it's a filiment issue

#

I'll try washing the bed again tho, just to be sure

stone bridge Jul 31, 2023, 12:20 PM

#

dire canyon Sadly it failed still! Could it be poor quality filament?

did you level your bed and adjust the z offset?

#Bed Adhesion