Ender 3 V2 Neo overheating.. I think?

[frosty fern]

did you remove or format the sd card?

[fluid locust]

Im still new so i dont understand what you mean sorry.

[frosty fern]

....

okay. im sorry but if that question is already too complicated i dont have the nerves today. if the issue is not solved by tomorrow ill try again

[fluid locust]

okay

[unkempt gorge]

Check heat cart and thermistor

But try new SD csrd

Do you have an infrared temp gun?

[fluid locust]

not that i know of

[frosty fern]

So @fluid locust the printer you have saves all its settings usally on the sd card you also put stuff you want to print on.

That includes the data for how the temperature is controled

So if you removed the sd card or formated it there is a chance your printer runs on its settings stored on the board or default values creating your issue

[fluid locust]

that might have been it is it possible to get that file back?

or what it might be called

[frosty fern]

it only applies if you formated the sd card thats why i asked.

[fluid locust]

looks like it was on quick format

[fluid locust]

i think i formatted a while back is it possible to get the settings for my 3d printer back

[frosty fern]

no

but i think you have the thing for it already build into your printer

pid tune

it should be somewhere in your printers menue calibration or so

[fluid locust]

if its in my 3d printer already then what would be the reason my 3d printer is cooling down?

[frosty fern]

https://www.3dmakerengineering.com/blogs/3d-printing/pid-tuning-marlin-firmware this

or just creality firmware

but i think under control or temperature you have the setting to run a pid tune

[fluid locust]

okay thank so much ill try it out

[frosty fern]

you can also check if the silicone sock is still where it should be

that black rubbery thing around your hotend

[fluid locust]

okie dokie

[fluid locust]

I PID tuned it and it worked for like 5 mins then started to beep again

[fluid locust]

I checked and it looks like the black silicone sock near the nozzle was fine and where it was where it should be

[frosty fern]

Hmm thats odd.

If you heat up and wiggle the cable from the print head do your values change?

[fluid locust]

I changed out the nozzle with the spare one that the printer came with and so far it working and screaming

ill tell you if it starts to beep again