!level
#can someone tell me why this is happening
shy mesa
spiral hawkBOT
shy mesa
Your bed is not level. One side is much higher than the other.
torpid fable
ive got abl only but my printer must not be abl`ing properly
torpid fable
Right is befor left after is that better?
shy mesa
You tell me. Compare it to the diagram above.
From here looks like it’s still too far away but maybe some else can help with the abl
torpid fable
i tested some more and after trying out both directions nothing has changed
rain leaf
ive got abl only but my printer must not be abl`ing properly
Abl does not mean you don't need to level the bed manually
Abl can only correct so much
Anything like 1.5mm or higher will screw it up
Also have you calibrated the necessary stuff?
torpid fable
The problem is I can only use abl and nothing else but pls tell me if this problem is fixed?
Is it supposed to look like that?
rain leaf
The problem is I can only use abl and nothing else but pls tell me if this probl...
What do you mean you can't adjust the build plate?
What model printer do you have?
peak leaf
Your Problem is mentioned in that Post. Is a twist in the x-axis. You can solve it via Custom-Firmeware or by mechanical solutions
peak leaf
What do you mean you can't adjust the build plate?
Sovol has a fixed buildplate, No screws to adjust it
peak leaf
Still does seems like not good
rain leaf
That is either not close enough or it's a flow issue
torpid fable
So a Clogged nozzle?