still rapids
Printer Adventurer 3
After several weeks of trying to diagnose an issue I have come to the conclusion that my gantry was uneven! So i fixed it, however now when i go to calibrate my old settings are way too close and it took 1-2 full mm of raising to get the nozzle off the print bed, what could have caused this? Is this normal? Did i maybe do something wrong despite me following the manufactures instructions?
still rapids
Never mind i found my answer 
still rapids
Also .... didnt you tell me it was not tilted?
according to a leveler
turns out the platform i have it on is also
not level
however after comparing a print bed leveler to a gantry it turns out its
not the same
so for the past 4 hours i have been trying to do said leveling and
i think i finally got i9t
also no solution, just endless leveling and sore fingers
i am now calibrating the no87zzle and will post print result
Calibration numbers, ?'s are spots where when i lowered there was an abrupt amount of tension on the paper
dire vessel
Seems normal so far. Not perfect but acceptable
still rapids
well so far i already can tell the bottom left one needs to be lowered..
not sticking
dire vessel
I remember that some said raft is a must on that printer but im not sure. Have you tried gluestick?