First Layer Becomes Stringy, within 2-3 minutes of build. essentially won’t print upwards | 3DMeltdown 3D Printing | Page 1

haughty barn May 26, 2023, 1:41 PM

#

#

@torn sapphire do you intend to awnser in the next 5 mins?

haughty barn May 26, 2023, 8:35 PM

#

you can ask here

torn sapphire May 26, 2023, 8:45 PM

#

Basically, my printer goes like 10 mins into the build , and then the extruder just like leaves the model . And don’t dispense any filament . is this a leveling related issue ?

#

haughty barn May 26, 2023, 8:54 PM

#

i guess if you check your gcode youll either have a corrupted file or a lot of retractions in a short time that half clog your printer

torn sapphire May 26, 2023, 11:05 PM

#

haughty barn i guess if you check your gcode youll either have a corrupted file or a lot of r...

How do I look and see if a file is corrupted

#First Layer Becomes Stringy, within 2-3 minutes of build. essentially won’t print upwards