glow in the dark Pla

[austere summit]

Ender 3 pro s1 with sonic pad
Have used hatchbox black pla with succes at 210/60 with no issues. Purched hatchbox glow in the dark pla. Printed same successful file in black with glow in the dark and have bed adhesion issues. Ive increased bed temps from 60 to 65 with no gains. Tried skirt and raft. The raft adhears but the first few layers of actual print do not stick to the raft lol. I get roughly 5 layers in and the nozzle ends up moving the print across the bed. Looking for auggestions, will get pictures later.

2nd or 3rd layer of raft prior to the 1st layer of the actual print. I have speeds as low as 20mm/s trying to get it to stick. With the black pla i was easily running 75mm/s withing any raft or brim with no adheasion issues. My black pla is in a dehumidifier, my glow in the dark is not, but i just opened it up and put it on my machine. Dont think it could be a moisture problem. Could be wrong

[strong wedge]

If thr filament was water cooled during production its mostly moist. About not sticking. Make sure your first layer is only .2 mm not .3mm

[austere summit]

I will check when i get home. Ill put the filement in the dryer and check moisture prior to printing another

Im printing at .12 i believe also

[strong wedge]

never really had succuess below .2 mm on a creality machine

[austere summit]

I have not had an issue yet and believe my quality has been pretty good. I will bunp it up to .2mm and try that. I just have not had an issue with adhesion since ive started and have gone thru a whole spool without adhesion issues

[strong wedge]

otherwise clean the bed with water and soap. ipa removes not everything unfortunaly