Just installed a sprite pro kit on my e3 max to print a bltouch mount but i just keep getting this error whenever i try to heat it
#Heating on Sprite extruder bootlooping
fervent needle
warm willow
could it be some power connector is not fully attached/defective after you changed the whole extruder?
fervent needle
could it be some power connector is not fully attached/defective after you chang...
I wouldnt think so cause ive fully unplugged an replugged everything 3x now
misty hazel
what temperatures are shown before you try to heat anything?
fervent needle
what temperatures are shown before you try to heat anything?
23
misty hazel
measure the resistance across the heater bed heater cartridge wires when it is disconnected. (the heater, not the temperature sensor)
fervent needle
?
misty hazel
do you have a multimeter?
fervent needle
Ima say no cause i uave no clue what that is
misty hazel
whelp. contact creality and get a replacement?
fervent needle
Ok now the printer is just boot looping whenever i try to preheat
fervent needle
Heating on Sprite extruder bootlooping
onyx tapir
did you clear you epprom
fervent needle
did you clear you epprom
I intialized it its not giving an option to clear
onyx tapir
thats the same if you made a new firmware
fervent needle
?
onyx tapir
it does the same in your case then clear epprom
after a firmware change .. you did change the firmware right?
fervent needle
Yeah i set it up with the sprite pro extruder firmware
fervent needle
Aight tried reinstalling firmware gonna try fiddling with wires next
onyx tapir
Maybe try a pid tune?
fervent needle
A what
onyx tapir
fervent needle
If i can beat the boot looping i will
fervent needle
Fixed boot looping but now im back to square one on it not heating past 26 then yelling at me heating failed