When printing different things my filament kinda just stops feeding, when printing there will be weird lines where the filament comes in and stops feeding. I have an Ender 5 Plus. Also lots of stringing.
#Filament Stops Feeding
pale wadi
I just cleaned out my nozzle and filament tube earlier today
Heat Creep was a big thing for me, idk if that’s the issue here
charred condor
No just several creality issues
One is your bed level is off. In hardware and software mostly. Youll need to turn that on in slicer stettings
Then i dont see a clip on your bowdentube pushfit. Maybe the tube moved and plastic got out
And creality sets retraction values notoriously too high
Like 5.5 or 6.5 mm at 50 mm/s or so
pale wadi
Then i dont see a clip on your bowdentube pushfit. Maybe the tube moved and plas...
The Blue Clip? I got that on there
The back tube? I’ll look at it
I’ll check the bed level, and i’ll check the retraction settings
charred condor
Oh cool didnt see
pale wadi
Does there need to be the blue clip on the back side?
Where the filament is loaded in
The first layer is always okay, once it gets to the second and third and so on it gets messed up
charred condor
Id say its no harm if both have one