#Prints fails after a few layers
lone lion
This is not the first print this has happened
It's not Gcode because my red pla printed it fine
The pla is also not brittle
jaunty gate
Heat creep?
lone lion
I don't think it would be
mint crescent
it prints fine in a different color? Have you done a temperature tower in your new color?
I have generally settled on 210C for all my colors but a few need more
lone lion
it prints fine in a different color? Have you done a temperature tower in your ...
I'm not sure how to do a temp tower
I'm running 220C
hollow cloud
sensor in the correct place?
lone lion
it prints fine in a different color? Have you done a temperature tower in your ...
Yes inland red pla worked fine but the magenta filament does not
mint crescent
I'm not sure how to do a temp tower
there's a tab for it on that esteps calibration I sent you, that's my preferred calibration sequence I gave you
mint crescent
I'm running 220C
also what machine are you on and how fast is it going
lone lion
Ender 3 pro base speed
mint crescent
because my temp towers say I should be running 195 with these filaments but I run it at 210 because my machine is tuned way faster
and you're running 220 which is even higher I would expect you to have problems, I sure do when I run at that temp
use that teachingtech guide to run off a temp tower and see what it tells you
sometimes the only way to tell is to perform the test, it could very well be that you're running at the right temp, even if I don't understand how that works
lone lion
It's just kinda odd because the red filament printed great at 220
hollow cloud
would not call that unexpected
lone lion
I guess additives
lone lion
I did print in magenta successfully but I don't remember the settings
hollow cloud
Odd got an image of thr old one?
Its rarely that they are so worn down or did you drag it across the build area by accident
lone lion
Odd got an image of thr old one?
The printer has been going since last night and printing normally