#Issues printing PETG about to full my hair out.

1 messages · Page 1 of 1 (latest)

coral narwhal
#

Hi All,

I am having issues with stringing and blobs with PetG I think it's an over extrustion issue and then it just gets dragged around and compounds over time. I noticed after a movement, at the beginning of a new extrustion it looks like I have excessive filiment for a little while. I noticed this while doing a retraction test print as you can see the first wall is almost 3x thicker then the others. Is this a retraction setting problem?

20230311_155427.jpg 20230311_155417.jpg
#

More information about my printer. It's converted to direct drive over bowden.

20230311_175136.jpg 20230311_175154.jpg
#

What it used to do before I changed out the nozzle. I now changed it 3 times as I thought that was the original issue. Stumped why I can't print anything now.

20230311_175255.jpg
coral narwhal
main pendant
#

Like is it weaker than normal

coral narwhal
#

FML I figured out what I did. So when I changed nozzles I thought heck let's recalibrate the esteps but I had the flow modifier reduced when I calibrated! So when I rebooted the printer the esteps were totally wrong!

#

Only 8 hours of troubleshooting my stupidity.......