Hi again,
I reduced my lift speeds to match the suggestion I got in here and the print seemed to be going well until about 75% in when a part of it just stopped printing, yet the support next to it kept printing fine. Any idea why?
#Print snapped off during printing but support seems fine
nova apex
Somehow seems worse with the new print than the old, as it only had a small gash and not the entire thing missing, but that could be a lot of factors i guess
nocturne beacon
You had it failing earlier just not completely
Is the build platform rock solid after the print? Is the model placed flat on platform or hanging completely on supports? What is your room/resin temperature?
polar cave
Hi again,
I reduced my lift speeds to match the suggestion I got in here and the...
hollow the print
check your FEP isnt fucked after this too
nova apex
Is the build platform rock solid after the print? Is the model placed flat on pl...
Build platform seemed secured after printing, everything was on supports, room temp was about 25 degrees c
nova apex
hollow the print
Yeah I'll have to try that, wanted it solid for the added weight but printer doesn't like that I guess and FEP looks fine, had to remove the stuff that got printed to it but no deformation in it
raven dune
Isn't there a setting to add a bleed hole the the resin leaks out as well? Don't know what slicer you're using so
strange palm
I use 3d builder to hollow and then just size a cylinder and subtract it. I had partial fail issues like this back when I set my resin to perfect exposure. I started adding 0.10s to my exposure times now. I lose a little detail but properly supported fails are almost never.