i’ve tried so many different exposure times , i have no idea what to do anymore …
#prints keep detaching from stabilizers?
torpid star
and i have adjusted my lift speed and what not
torpid star
i have tried a whole different thumb drive
i have adjusted angle / supports
anything bigger than a keycap wont print
it either sticks to fep or prints not connected to supports like this
pliant goblet
Have you tried setting the z 0 to a lower pos?
It also helps sanding the build plate with sand paper to improve adhesion
torpid star
Have you tried setting the z 0 to a lower pos?
wdym?
pliant goblet
You need to level your bed
Not sure how you call it at elegoo, but you usually do it before starting to use the printer
So you place your leveling paper onto the screen, unscrew/loosen the bed and then lower the bed until it hits the screen with the paper
Then you set this to your print start position and maybe go like 0.05 mm lower
torpid star
yea ive leveled the bed
any other thing you could think of?
i leveled it earlier today
<@&637102730967515136> @pliant goblet
gusty flare
Please do not ping Mods for help with printers.
torpid star
im so sorry i knew right as soon as i did it ;-; i didnt think itd do that
pliant goblet
I don't know more
My old anycubic printer is already dead for a half year
torpid star
damn
faint fog
faint fog
this guy
its a thing
90% of people looking for help just have their lift setting too high
lol
torpid star
yea i seen that and that was the first thing i thought of ngl