#Why is this stringy?
trim vale
brittle needle
caused usually by retraction wipe i believe
sand coral
What material /settings/ printer?
mental crow
Change retraction settings to 8 mm retraction and 70 mm per sec
Also turn on retraction at layer change
mental crow
For me 7,5 was still creating stringing so i did 8 and the stringing was gone
mental crow
Thats way too much unless you have more then 50 cm bowden tube
I do have bowden tube but not 50 cm
sand coral
8 should be so much that you draw back air in the nozzle creating airpockets that cause stringing then
mental crow
8 should be so much that you draw back air in the nozzle creating airpockets tha...
Cant find my 7,5 one but my sister pulled most of the stringing off of 3
sand coral
Its also possible if you are too fast you rip thr nonmolten filament from thr molten one
mental crow
True, tho i did get these settings from a guy on yt
He suggested to never go above 10 mm
brittle needle
He suggested to never go above 10 mm
it depends on the printer